Chery Tiggo Workshop Manuals and Repair Manuals

To check the transmission fluid level in a Chery Tiggo, the engine must be running and the vehicle must be on a level surface. Locate the transmission dipstick, pull it out, and wipe it clean. Reinsert the dipstick, remove it, and check the fluid level against the markings on the dipstick.

To replace a headlight bulb in a Chery Tiggo, first, locate the headlight assembly and remove the retaining clips or screws. Then, remove the old bulb and install the new one, making sure to properly align it in the socket. Finally, reassemble the headlight assembly.

To replace a taillight bulb in a Chery Tiggo, first, locate the taillight assembly and remove the retaining clips or screws. Then, remove the old bulb and install the new one, making sure to properly align it in the socket. Finally, reassemble the taillight assembly.

To replace the air filter in a Chery Tiggo, locate the air filter housing, release the clips, and remove the old air filter. Install the new air filter, making sure to properly align it with the housing, and secure the clips.

To replace the battery in a Chery Tiggo, first, remove the negative cable, then the positive cable. Next, remove the battery hold-down clamp and lift out the old battery. Install the new battery and reconnect the cables.

To replace the brake pads in a Chery Tiggo, first, remove the wheel and caliper. Then, remove the old brake pads and install the new ones. Finally, reassemble the caliper and wheel and test the brakes for proper function.

To replace the cabin air filter in a Chery Tiggo, locate the cabin air filter housing, release the clips, and remove the old filter. Install the new filter, making sure to properly align it with the housing, and secure the clips.

To replace the serpentine belt in a Chery Tiggo, first, locate the belt routing diagram. Then, use a serpentine belt tool or wrench to loosen the tensioner, remove the old belt, and install the new one. Finally, tighten the tensioner and verify proper belt tension.

To replace the spark plugs in a Chery Tiggo, first, locate the spark plug wires or coil packs. Remove the old spark plugs and install the new ones, making sure to properly gap them. Finally, reconnect the spark plug wires or coil packs.

To reset the oil change light in a Chery Tiggo, turn the ignition to the “on” position without starting the engine. Depress the accelerator pedal three times within 10 seconds. The oil change light should flash and then turn off, indicating that the reset was successful.

The transmission fluid in a Chery Tiggo should be changed every 30,000 miles or as recommended by the manufacturer. Regular transmission fluid changes can help prevent transmission failure and prolong the life of the vehicle’s transmission.

The tires on a Chery Tiggo should be rotated every 5,000 to 7,500 miles or as recommended by the manufacturer. Regular tire rotations can help promote even tire wear and prolong the life of the tires.

The check engine light in a Chery Tiggo indicates that the vehicle’s onboard diagnostic system has detected a problem with the engine or emission control system. It is recommended to have the vehicle diagnosed and repaired by a certified mechanic.

The recommended engine oil for a Chery Tiggo is 5W-30 or 10W-30. Using the correct engine oil is important for maintaining proper engine lubrication, reducing wear and tear, and optimizing engine performance.

The recommended tire pressure for a Chery Tiggo is 32 psi. Adequate tire pressure is essential for maintaining optimum tire performance, fuel efficiency, and overall vehicle stability.