Holden Commodore VE Workshop Manuals and Repair Manuals

To change the oil in a Holden Commodore VE, start by locating the oil drain plug underneath the engine. Use a wrench to loosen the plug and let the old oil drain into a suitable container. Once all the oil has drained, replace the drain plug and proceed to remove the old oil filter. Install a new filter, and then refill the engine with the recommended amount and type of oil.

To replace a headlight bulb in a Holden Commodore VE, open the hood and locate the back of the headlight assembly. Twist the bulb socket counterclockwise to remove it from the assembly. Pull out the old bulb and insert a new one, being careful not to touch the glass with bare hands. Reinstall the bulb socket into the headlight assembly by twisting it clockwise.

To replace the battery in a Holden Commodore VE, start by locating the battery, which is typically located in the engine bay. Disconnect the negative (-) terminal first, followed by the positive (+) terminal. Remove any retaining brackets or clamps, and carefully lift out the old battery. Place the new battery in the same position and reconnect the terminals, ensuring the correct polarity.

The recommended tire pressure for a Holden Commodore VE can be found in the owner's manual or on a sticker located on the driver's door jamb. It is important to maintain the correct tire pressure as specified by the manufacturer, as it affects the vehicle's handling, fuel efficiency, and tire wear. Use a tire pressure gauge to check the pressure regularly and adjust it as needed.

A Holden Commodore VE requires a specific type of coolant, which can be found in the owner's manual or on a sticker under the hood. The coolant should meet the manufacturer's specifications to ensure proper engine cooling and protection against freezing and corrosion. It is recommended to use a premixed coolant that is compatible with the vehicle's cooling system.