Honda Ridgeline Workshop Manuals and Repair Manuals

To change the oil in your Honda Ridgeline, start by placing a drain pan under the vehicle and removing the oil drain plug. Allow the old oil to fully drain out before replacing the drain plug and tightening it securely. Then, locate the oil filter and remove it using an oil filter wrench. Replace the old oil filter with a new one, making sure to lubricate the rubber gasket on the new filter before installing it. Finally, add the recommended amount and type of oil to the engine, checking the oil level using the dipstick.

To check and refill the coolant in your Honda Ridgeline, start by ensuring the engine is cool. Locate the coolant reservoir under the hood, typically marked with "Engine Coolant" or "Antifreeze." The reservoir should have a minimum and maximum level indicator. If the coolant level is below the minimum mark, carefully remove the cap and add a 50/50 mixture of coolant and distilled water until it reaches the maximum mark. Use a funnel if necessary to avoid spills. After refilling, securely tighten the cap back in place and ensure no coolant is leaking from the system.

To check the tire pressure in your Honda Ridgeline, start by obtaining a tire pressure gauge and ensuring the tires are cool. Remove the valve cap from each tire and firmly press the gauge onto the valve stem. The gauge will display the current tire pressure, which should match the recommended pressure specified in the vehicle's manual. If the pressure is too low, add air until it reaches the recommended level. If it is too high, release air until it reaches the correct pressure. Repeat this process for all four tires, including the spare tire.

To check the transmission fluid level in your Honda Ridgeline, start by ensuring the engine is warm and the vehicle is on a level surface. Locate the transmission dipstick, usually near the back of the engine compartment. Remove the dipstick and wipe it clean with a lint-free cloth or paper towel. Reinsert the dipstick fully, then remove it again to check the fluid level. The fluid should be between the "Low" and "High" marks on the dipstick. If the level is low, add the recommended transmission fluid slowly through the dipstick tube, checking the level frequently until it reaches the correct range.

To replace a blown fuse in your Honda Ridgeline, start by locating the fuse box, which is usually found under the dashboard or in the engine compartment. Use the fuse box diagram in the repair manual to identify the specific fuse that needs to be replaced. Once identified, use a fuse puller or a pair of needle-nose pliers to remove the blown fuse. Replace it with a new fuse of the same amperage rating, ensuring it is fully seated in the fuse box. If the new fuse blows again immediately or after a short period, there may be an underlying electrical issue that requires further investigation.

To replace a brake light bulb in your Honda Ridgeline, start by opening the tailgate and locating the access panel on the inside of the tailgate. Remove the screws or clips securing the access panel and carefully remove it. Locate the brake light bulb socket and twist it counterclockwise to remove it from the tail light assembly. Remove the old bulb by gently pulling it straight out and replace it with a new bulb. Reinstall the bulb socket into the tail light assembly, ensuring it is securely in place, and then reattach the access panel.

To replace a headlight bulb in your Honda Ridgeline, start by opening the hood and locating the back of the headlight assembly. Disconnect the electrical connector from the bulb by gently pressing the release tab and pulling it away. Then, twist the bulb socket counterclockwise to remove it from the assembly. Remove the old bulb and replace it with a new one, being careful not to touch the glass portion of the bulb. Reinstall the bulb socket into the assembly and reconnect the electrical connector. Finally, test the new bulb by turning on the headlights.

To replace the serpentine belt

To replace the cabin air filter in your Honda Ridgeline, start by locating the cabin air filter housing, which is usually located behind the glove box or under the dashboard. Open the glove box and remove any contents or stops that prevent it from fully opening. Squeeze the sides of the glove box inward to release the stops and allow it to swing down, giving you access to the filter housing. Remove the filter housing cover by unclipping or unscrewing it, then slide out the old cabin air filter. Replace it with a new filter of the same size and type, making sure it is oriented correctly. Reinstall the filter housing cover and close the glove box.

To replace the windshield wiper blades on your Honda Ridgeline, start by lifting the wiper arm away from the windshield, ensuring it remains in the raised position. Locate the release tab on the wiper blade connector and press it to release the blade. Slide the old blade out of the connector and discard it. Align the new wiper blade with the connector and slide it in until it clicks into place. Gently lower the wiper arm back onto the windshield. Repeat these steps for the other wiper blade as well.

To reset the maintenance light on your Honda Ridgeline, start by turning the ignition switch to the "ON" position without starting the engine. Press and hold the select/reset button on the instrument panel until the maintenance light begins to blink. Release the button, then press and hold it again until the maintenance light goes out. Turn off the ignition and then start the engine to ensure the maintenance light has been successfully reset. If the maintenance light continues to illuminate, there may be an unresolved issue that requires further attention or consultation with the repair manual.

It is recommended to change the air filter in your Honda Ridgeline every 15,000 to 30,000 miles or as specified in the vehicle's maintenance schedule. However, if you frequently drive in dusty or dirty conditions, it may be necessary to change the air filter more frequently. A clogged or dirty air filter can restrict airflow to the engine, reducing performance and fuel efficiency. Regularly inspecting and replacing the air filter will help maintain optimal engine performance and prolong the lifespan of other engine components.

If your Honda Ridgeline won't start, there are a few possible causes to consider. First, check the battery connections to ensure they are tight and clean. If the connections are good, test the battery voltage using a multimeter. If the battery is low, try jump-starting the vehicle or replacing the battery if necessary. If the battery is not the issue, it could be a problem with the starter motor or ignition system, and it may be necessary to consult the repair manual for further troubleshooting steps.

The recommended engine oil for your Honda Ridgeline will depend on the model year and engine type. Consult the vehicle's owner's manual or the repair manual for the specific oil viscosity and performance specifications. Typically, a high-quality synthetic blend or full synthetic oil with the correct viscosity rating, such as 5W-20 or 0W-20, is recommended for optimal engine protection and performance. Using the correct engine oil and adhering to the recommended oil change intervals will help ensure the longevity and efficient operation of your Honda Ridgeline's engine.