Infiniti EX35 Workshop Manuals and Repair Manuals

To change the oil in your Infiniti EX35, start by locating the oil drain plug underneath the vehicle. Use a wrench to loosen and remove the plug, allowing the old oil to drain into a catch pan. Once the oil has fully drained, replace the drain plug and remove the oil filter. Install a new oil filter and then refill the engine with the recommended amount and type of oil.

To check the engine coolant level in your Infiniti EX35, make sure the engine is cool and the vehicle is parked on a level surface. Locate the coolant reservoir, usually marked with high and low level indicators. The coolant level should be between these indicators. If necessary, add the recommended coolant type to bring the level within the appropriate range.

To check the transmission fluid level in your Infiniti EX35, start the engine and let it warm up to normal operating temperature. Park the vehicle on a level surface and engage the parking brake. Locate the transmission dipstick, typically marked with a yellow or red handle, and pull it out. Wipe the dipstick clean, reinsert it fully, and then remove it again to check the fluid level. The fluid should be within the designated range on the dipstick.

To replace a fuse in your Infiniti EX35, locate the fuse box, which is usually located in the engine compartment or under the dashboard. Open the fuse box cover and locate the fuse that corresponds to the malfunctioning component. Use a fuse puller or a pair of needle-nose pliers to remove the old fuse and replace it with a new one of the same amperage rating. Make sure the new fuse is properly seated and replace the fuse box cover.

To replace a headlight bulb in your Infiniti EX35, first, locate the headlight assembly and access the back of it. Disconnect the electrical connector from the bulb, then twist and remove the bulb from the assembly. Install the new bulb by twisting it into place and reconnect the electrical connector. Test the headlight to ensure it is working properly.

To replace the cabin air filter in your Infiniti EX35, locate the cabin air filter housing, which is usually located behind the glove compartment or under the dashboard. Open the housing and remove the old filter, taking note of its orientation. Install the new cabin air filter in the same orientation as the old one, making sure it is properly seated. Close the housing and ensure it is securely latched.

To replace the windshield wipers on your Infiniti EX35, lift the wiper arm away from the windshield and locate the release tab on the wiper blade assembly. Press the release tab and slide the old wiper blade off the wiper arm. Align the new wiper blade with the arm and slide it onto the wiper arm until it clicks into place. Lower the wiper arm back onto the windshield.

To reset the maintenance reminder light on your Infiniti EX35, turn the ignition key to the "ON" position without starting the engine. Press and hold the trip odometer reset button until the maintenance reminder light flashes and then turns off. Release the button and the maintenance reminder light should be reset.

If you are experiencing issues with a power window in your Infiniti EX35, start by checking the fuse associated with the power window circuit. If the fuse is intact, try operating the window from both the driver's control panel and the individual window switch. If the window does not respond to either control, it may be a motor or regulator issue and further diagnosis or repair may be necessary.

The air filter in your Infiniti EX35 should be replaced approximately every 12,000 to 15,000 miles or as recommended in your automotive repair manual. A dirty or clogged air filter can restrict airflow to the engine, leading to decreased performance and fuel efficiency. Regularly inspect the air filter and replace it when necessary.

It is recommended to rotate the tires on your Infiniti EX35 approximately every 5,000 to 7,500 miles or as advised in your automotive repair manual. Regular tire rotations help ensure even tread wear, improve traction, and extend the lifespan of your tires. Follow the specific rotation pattern outlined in the manual for your vehicle.

The recommended tire pressure for your Infiniti EX35 can be found in the owner's manual or on a sticker located on the driver's side door jamb. It is important to maintain the correct tire pressure to ensure optimal handling, fuel efficiency, and tire longevity. Use a tire pressure gauge to check and adjust the pressure accordingly.

If your Infiniti EX35's battery is dead, you can jump-start the vehicle using jumper cables and a second vehicle with a charged battery. Connect the positive (red) jumper cable clamp to the positive terminal of the dead battery, then connect the other end of the positive jumper cable to the positive terminal of the charged battery. Connect the negative (black) jumper cable clamp to the negative terminal of the charged battery, then connect the other end of the negative jumper cable to a metal part of your Infiniti EX35 away from the dead battery. Start the second vehicle and let it run for a few minutes to charge the dead battery, then try starting your Infiniti EX35.

The type of brake fluid recommended for your Infiniti EX35 can be found in the owner's manual or on a label located on the brake fluid reservoir cap. Typically, a DOT 3 or DOT 4 brake fluid is recommended. It is important to use the correct type of brake fluid to maintain proper braking performance and prevent damage to the braking system.

It is important to use the correct type of coolant in your Infiniti EX35 to ensure optimal performance and prevent engine damage. Consult your Infiniti EX35 automotive repair manual for the specific coolant recommendation. Typically, a long-life ethylene glycol-based coolant with a 50/50 ratio of coolant to distilled water is recommended.