Iveco Massif Workshop Manuals and Repair Manuals

Every Manual available online - found by our community and shared for FREE. Enjoy!

Iveco Massif

The Iveco Massif is a utility 4×4 vehicle mainly aimed at the utility services and military markets and was part of Iveco s 4×4 and off-road range which also includes the Trakker lorry and Daily 4×4 van. Massif was produced by Santana Motors from 2007 to 2011 and its rebadged and restyled version of the Santana PS-10. In 2010, due to poor sales and Fiat Group's ability to serve the European 4×4 market with imported Jeep vehicles, Iveco decided to stop the agreement with Santana. The Massif is fitted with a 6-speed ZF 6S400 overdrive manual gearbox with high and low range ratios. No automatic was available.

Iveco Massif FAQ's

How do I change the oil in my Iveco Massif?

To change the oil in your Iveco Massif, you will need to locate the oil drain plug underneath the vehicle and remove it to drain the old oil. Once the old oil is drained, replace the drain plug and refill the engine with the recommended amount of new oil. Be sure to also replace the oil filter during this process to ensure optimal performance and longevity of your engine.

How do I check the brake fluid level in my Iveco Massif?

To check the brake fluid level in your Iveco Massif, locate the brake fluid reservoir, usually located near the firewall on the driver's side. Ensure the vehicle is parked on level ground, and remove the cap from the reservoir. The fluid level should be between the minimum and maximum markers on the side of the reservoir. If it is low, add the recommended type of brake fluid to bring it to the correct level.

How do I check the transmission fluid level in my Iveco Massif?

To check the transmission fluid level in your Iveco Massif, start the engine and let it idle for a few minutes to warm up. Locate the transmission dipstick, usually near the back of the engine bay, and pull it out. Wipe it clean, reinsert it fully, and then remove it again to check the fluid level. The fluid should be within the designated range on the dipstick. If it is low, add the recommended type of transmission fluid gradually, checking the level frequently until it reaches the correct range.

How do I replace a broken headlight bulb in my Iveco Massif?

To replace a broken headlight bulb in your Iveco Massif, access the bulb by opening the hood and locating the back of the headlight assembly. Disconnect the wiring harness from the bulb, then remove the bulb by twisting it counterclockwise. Install the new bulb by reversing these steps, ensuring it is securely in place before reconnecting the wiring harness.

How do I replace a faulty fuse in my Iveco Massif?

To replace a faulty fuse in your Iveco Massif, locate the fuse box, usually found in the engine compartment or under the dashboard. Open the fuse box cover and locate the fuse that corresponds to the malfunctioning component. Using a fuse puller or a pair of needle-nose pliers, carefully remove the faulty fuse and replace it with a new fuse of the same amperage rating. Ensure the new fuse is securely in place before closing the fuse box cover.

How do I replace a malfunctioning fuel filter in my Iveco Massif?

To replace a malfunctioning fuel filter in your Iveco Massif, locate the filter, usually near the fuel tank or along the fuel lines. Before removing the old filter, relieve the fuel pressure by removing the fuel pump fuse or relay and starting the engine until it stalls. Disconnect the fuel lines from the filter, then remove and replace the old filter with a new one. Reconnect the fuel lines, ensuring they are properly secured, and then start the engine to check for any leaks.

How do I replace a worn-out serpentine belt in my Iveco Massif?

To replace a worn-out serpentine belt in your Iveco Massif, locate the belt tensioner pulley and use a wrench or socket to relieve tension on the belt. Slide the belt off the pulleys, noting the routing for installation of the new belt. Install the new belt by following the correct routing, ensuring it is properly seated on all pulleys. Finally, release the tensioner to apply tension to the new belt.

How do I reset the maintenance light on my Iveco Massif?

To reset the maintenance light on your Iveco Massif, turn the ignition key to the "ON" position without starting the engine. Press and hold the trip meter reset button until the maintenance light starts flashing. Release the button, turn off the ignition, and then start the vehicle. The maintenance light should be reset, indicating that the maintenance reminder has been cleared.

How often should I replace the air filter in my Iveco Massif?

It is recommended to replace the air filter in your Iveco Massif every 12,000 to 15,000 miles or as specified in your vehicle's manual. A clean air filter ensures proper airflow to the engine, improving fuel efficiency and protecting the engine from contaminants. If you frequently drive in dusty or dirty conditions, it may be necessary to replace the air filter more frequently.

How often should I replace the spark plugs in my Iveco Massif?

It is recommended to replace the spark plugs in your Iveco Massif every 30,000 miles or as specified in your vehicle's manual. Regularly changing the spark plugs ensures proper combustion and ignition, which helps maintain fuel efficiency and engine performance. If you notice signs of misfiring or reduced power, it may be time to replace the spark plugs earlier than recommended.

What is the recommended tire pressure for my Iveco Massif?

The recommended tire pressure for your Iveco Massif can be found in your vehicle's manual or on a sticker located on the driver's side door jamb. It is important to maintain the recommended tire pressure to ensure proper handling, tire longevity, and fuel efficiency. Regularly check the tire pressure and adjust as needed.

What should I do if my Iveco Massif is overheating?

If your Iveco Massif is overheating, it is important to pull over safely and turn off the engine immediately. Allow the engine to cool down before attempting any further diagnosis or repairs. Check the coolant level and ensure there are no leaks or blockages in the cooling system. If the issue persists, it is recommended to seek professional assistance.

What type of coolant should I use in my Iveco Massif?

It is recommended to use a high-quality, ethylene glycol-based coolant with the appropriate mixture of water for your Iveco Massif. This coolant should meet the specifications outlined in your vehicle's manual. It is important to use the correct coolant to prevent engine overheating and to provide adequate corrosion protection for the cooling system.

What type of engine oil should I use in my Iveco Massif?

It is recommended to use a high-quality synthetic or semi-synthetic engine oil with the viscosity grade specified in your vehicle's manual. The recommended oil will provide optimal lubrication and protection for your Iveco Massif's engine, especially during extreme operating conditions. Regularly check the oil level and change the oil at the intervals outlined in the manual to maintain engine performance.

Why is my Iveco Massif's air conditioning not cooling enough?

If your Iveco Massif's air conditioning is not cooling enough, there could be several reasons. Firstly, check if the cabin air filter is dirty or clogged, as this can restrict airflow. Also, ensure that the condenser is clean and free from debris, as a dirty condenser can affect cooling efficiency. If these checks do not resolve the issue, it is recommended to have the air conditioning system inspected by a qualified technician.