Lancia Prisma Workshop Manuals and Repair Manuals

To adjust the headlights on your Lancia Prisma, park the vehicle on a level surface facing a wall or garage door. Measure the height from the ground to the center of each headlight and mark the wall at the same height. Back the vehicle up about 25 feet and turn on the headlights. Use the adjustment screws located on the back of the headlight assembly to align the beams so that they hit the marked spots on the wall at the correct height. Repeat the process for the other headlight.

To change the oil in your Lancia Prisma, you will need to locate the oil drain plug underneath the engine and remove it to drain the old oil. Once the oil has completely drained, replace the drain plug and then locate the oil filter. Remove the old oil filter and replace it with a new one. Finally, refill the engine with the recommended amount and type of oil specified in the manual.

To check and adjust the tire pressure in your Lancia Prisma, start by locating the recommended tire pressure values on the sticker inside the driver's side door jamb or in the owner's manual. Use a tire pressure gauge to measure the pressure of each tire and compare it to the recommended values. If the pressure is too low, add air using a tire inflator, and if it is too high, release air using a tire pressure gauge. Repeat the process for all tires, including the spare.

To check the battery voltage in your Lancia Prisma, you will need a voltmeter or multimeter. Set the meter to the DC voltage setting and connect the positive (red) probe to the positive terminal of the battery and the negative (black) probe to the negative terminal. Read the voltage displayed on the meter. A fully charged battery should read around 12.6 to 12.8 volts. If the voltage is significantly lower, it may indicate a weak or discharged battery that needs recharging or replacement.

To check the engine coolant level in your Lancia Prisma, make sure the engine is cool. Locate the coolant reservoir, which is typically a translucent plastic container near the radiator. The reservoir will have minimum and maximum level markings. Check the coolant level against these markings and add coolant if necessary. It is important to use the correct coolant type and mix it with water according to the manufacturer's recommendations.

To replace a blown fuse in your Lancia Prisma, first, locate the fuse box, which is usually found in the engine compartment or under the dashboard. Consult the owner's manual or the fuse box cover to identify the fuse that corresponds to the failed component. Use a fuse puller or a pair of pliers to carefully remove the blown fuse. Replace it with a new fuse of the same amperage rating. Make sure the new fuse is properly seated and then close the fuse box.

To replace a burnt-out headlight bulb in your Lancia Prisma, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector from the bulb socket. Remove the retaining clip or ring that holds the bulb in place. Carefully pull out the old bulb and insert the new one, making sure not to touch the glass part of the bulb with your bare hands. Reinstall the retaining clip or ring, reconnect the electrical connector, and test the headlight to ensure proper operation.

To replace the air filter in your Lancia Prisma, first, locate the air filter housing, which is usually located near the engine intake. Open the housing by removing the clips or screws that hold it in place. Take out the old air filter and inspect it for dirt and debris. If it is dirty or clogged, replace it with a new one that matches the specifications outlined in the owner's manual. Close the air filter housing and ensure it is securely fastened.

To replace the brake pads in your Lancia Prisma, start by loosening the lug nuts on the wheel where you want to replace the brake pads. Lift the vehicle using a jack and secure it with jack stands. Remove the lug nuts and the wheel to gain access to the brake caliper. Use a brake caliper piston tool to compress the piston back into the caliper. Remove the old brake pads and replace them with new ones. Reinstall the wheel, tighten the lug nuts, and lower the vehicle.

To replace the cabin air filter in your Lancia Prisma, first, locate the cabin air filter housing, which is usually located behind the glove compartment or under the dashboard. Open the housing by releasing the clips or removing the screws that hold it in place. Take out the old cabin air filter and inspect it for dirt and debris. If it is dirty or clogged, replace it with a new one that matches the specifications outlined in the owner's manual. Close the cabin air filter housing and ensure it is securely fastened.

To replace the windshield wipers in your Lancia Prisma, start by lifting the wiper arm away from the windshield. Locate the release tab or button on the wiper blade assembly. Press or slide it to release the blade from the wiper arm. Install the new wiper blade by aligning the adapter or hook with the wiper arm and pressing it into place until it clicks. Finally, lower the wiper arm back onto the windshield and test the new wipers to ensure proper operation.

To reset the maintenance light in your Lancia Prisma, turn the ignition switch to the "ON" position without starting the engine. Locate the trip odometer button and press and hold it. While holding the button, turn the ignition switch to the "OFF" position and then back to the "ON" position. Continue to hold the trip odometer button until the maintenance light resets, usually after about 10 seconds. Release the button and start the engine to confirm that the maintenance light has been successfully reset.

The spark plugs in your Lancia Prisma should be replaced according to the manufacturer's recommended maintenance schedule, which is typically every 30,000 to 50,000 miles or every 3 to 5 years, whichever comes first. However, it is always recommended to consult the owner's manual for the specific maintenance intervals for your vehicle, as they can vary depending on the engine type and driving conditions.

It is recommended to use a high-quality ethylene glycol-based coolant in your Lancia Prisma. This type of coolant provides excellent heat transfer and corrosion protection for the engine. Make sure to use a coolant that is specifically formulated for use in aluminum engines, as the Lancia Prisma has an aluminum engine block.

The type of transmission fluid to use in your Lancia Prisma depends on the transmission type. If you have a manual transmission, it is recommended to use a high-quality manual transmission fluid that meets the specifications outlined in the owner's manual. For automatic transmissions, use a fluid that is specifically formulated for your transmission type, such as Dexron or Mercon. Consult the owner's manual or contact a certified Lancia dealership for the exact type and specifications.