Nissan Almera Workshop Manuals and Repair Manuals

Every Manual available online - found by our community and shared for FREE. Enjoy!

Nissan Almera

The Nissan Almera was a small family car from Nissan, Japan. It was introduced in 1995, and aimed for the European market, its first generation was derived from the Nissan Pulsar and second generation was derived from the Nissan Bluebird Sylphy. The shape of this car was quite attractive with soft, round edges and a wide body shape. The name is currently also being used for several other versions of the car: the South Korean-manufactured Samsung SM3, in various export markets worldwide; the Nissan Latio, throughout the Southeast Asian markets; the second generation Nissan Bluebird Sylphy in Russia. The name Alméras was a family name of French racing drivers during the 1980s.

Nissan Almera FAQ's

How do I change the air filter in my Nissan Almera?

To change the air filter in your Nissan Almera, locate the air filter housing, which is usually located near the engine. Remove the clips or screws that secure the housing and carefully lift off the cover. Take out the old air filter and replace it with a new one, ensuring it is properly seated in the housing. Reattach the cover, secure it with the clips or screws, and make sure it is sealed tightly to prevent any unfiltered air from entering the engine.

How do I change the oil in my Nissan Almera?

To change the oil in your Nissan Almera, first, park the car on a level surface and warm up the engine. Locate the oil drain plug underneath the engine and use a wrench to remove it. Allow the old oil to drain completely, then replace the drain plug and remove the oil filter. Install a new oil filter, tighten it by hand, and finally, refill the engine with the recommended amount of fresh oil.

How do I check the engine coolant level in my Nissan Almera?

To check the engine coolant level in your Nissan Almera, ensure the engine is cool and the vehicle is parked on a level surface. Locate the coolant reservoir, usually a translucent plastic container near the radiator. The reservoir will have minimum and maximum level markings. If the coolant level is below the minimum mark, remove the cap and add a 50/50 mixture of coolant and distilled water until it reaches the maximum mark. It's important to use the recommended type of coolant specified in the owner's manual.

How do I check the transmission fluid in my Nissan Almera?

To check the transmission fluid in your Nissan Almera, start the engine and let it run for a few minutes to warm up. Park the car on a level surface, engage the parking brake, and shift the transmission through each gear position, pausing briefly in each one. Locate the transmission dipstick, typically labeled "ATF" or "Transmission," and remove it. Wipe the dipstick clean, reinsert it fully, and then remove it again to check the fluid level. The fluid should be within the designated range indicated on the dipstick. If it is low, add the recommended type of transmission fluid through the dipstick tube.

How do I replace a fuse in my Nissan Almera?

To replace a fuse in your Nissan Almera, first, identify the fuse box location, which is typically under the dashboard or in the engine compartment. Open the fuse box cover and locate the fuse corresponding to the malfunctioning component. Use the provided fuse puller or a pair of needle-nose pliers to carefully remove the fuse. Inspect the fuse to see if it is blown, indicated by a broken wire inside. If necessary, replace the blown fuse with a new one of the same amperage rating. Reinstall the fuse box cover and test the component to ensure it is functioning properly.

How do I replace a headlight bulb in my Nissan Almera?

To replace a headlight bulb in your Nissan Almera, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector from the bulb, then twist and remove the bulb holder. Replace the old bulb with a new one, making sure not to touch the glass with your bare hands. Reinstall the bulb holder, reconnect the electrical connector, and test the headlights to ensure they are functioning properly.

How do I replace a taillight bulb in my Nissan Almera?

To replace a taillight bulb in your Nissan Almera, open the trunk or liftgate and locate the access panel behind the affected taillight assembly. Remove the screws or clips securing the panel and carefully pull it off. Twist and remove the bulb socket from the taillight assembly, then remove the old bulb from the socket. Install a new bulb, making sure it is securely seated, and reattach the bulb socket to the taillight assembly. Place the access panel back in position and secure it with the screws or clips.

How do I replace the brake pads on my Nissan Almera?

To replace the brake pads on your Nissan Almera, first, ensure the car is safely lifted and supported on jack stands. Remove the wheels to access the brake calipers. Use a wrench or socket to remove the caliper bolts and carefully lift the caliper off the rotor. Take out the old brake pads and install the new ones, making sure they are properly seated in the caliper brackets. Reattach the caliper, tighten the bolts, and repeat the process for the other wheels. After completing the replacement, pump the brake pedal a few times to ensure proper brake operation before driving the vehicle.

How do I replace the cabin air filter in my Nissan Almera?

To replace

How do I replace the serpentine belt on my Nissan Almera?

To replace the serpentine belt on your Nissan Almera, locate the belt tensioner, typically a pulley with a square or hexagonal hole in the center. Insert a breaker bar or ratchet into the hole and rotate the tensioner counterclockwise to relieve tension on the belt. Slide the belt off the pulleys and carefully route the new belt, following the diagram located near the engine or in the owner's manual. Make sure the belt is properly seated on each pulley. Rotate the tensioner counterclockwise again and slide the new belt onto the pulleys. Release the tensioner, ensuring the belt is tight, and inspect the routing to confirm correct installation.

How do I reset the maintenance light on my Nissan Almera?

To reset the maintenance light on your Nissan Almera, turn the ignition switch to the ON position without starting the engine. Within 10 seconds, fully press and release the accelerator pedal five times. Wait for the maintenance light to start flashing, indicating the reset is complete. Turn the ignition off, then start the engine to confirm that the maintenance light is no longer illuminated. It's important to note that this procedure may vary slightly depending on the specific model year of your Nissan Almera.

How do I troubleshoot a rough idle in my Nissan Almera?

If your Nissan Almera is experiencing a rough idle, there are several potential causes to consider. Begin by checking for any vacuum leaks, which can disrupt proper air-fuel mixture. Inspect the spark plugs for wear or fouling, as faulty spark plugs can affect combustion efficiency. Additionally, a dirty or malfunctioning mass airflow sensor could be a culprit, as it measures the amount of air entering the engine. If these basic checks don't resolve the issue, it may be necessary to consult the Nissan Almera repair manual for further troubleshooting steps.

How often should I change the spark plugs in my Nissan Almera?

It is recommended to change the spark plugs in your Nissan Almera every 30,000 to 50,000 miles, or as specified in the owner's manual. Over time, spark plugs can become worn or fouled, resulting in poor engine performance and reduced fuel efficiency. Regularly replacing the spark plugs helps maintain smooth engine operation and optimal fuel combustion.

What are the recommended tire pressures for my Nissan Almera?

The recommended tire pressures for your Nissan Almera can be found in the owner's manual or on a sticker located on the driver's side door jamb. The proper tire pressure may vary depending on the tire size and load conditions, so it's important to refer to the specific information provided for your vehicle. Maintaining the correct tire pressures is crucial for optimal handling, fuel efficiency, and tire longevity.

What should I do if my Nissan Almera's battery is dead?

If your Nissan Almera's battery is dead, you can jump-start the car using jumper cables and another vehicle with a charged battery. Position the vehicles so that the batteries are close, but do not let them touch. Connect the positive (+) terminal of the dead battery to the positive terminal of the charged battery, then connect the negative (-) terminal of the charged battery to a metal part of the dead vehicle's engine. Start the engine of the vehicle with the charged battery, wait a few minutes, and then attempt to start your Nissan Almera.

Nissan Almera Manuals Index

Nissan Almera Workshop Manual

Nissan Almera Owners Manual

Related Models

Nissan Almera on Amazon

Nissan Almera and Tino Petrol Service and Repair Manual (Haynes Service and Repair Manuals)