Peugeot 607 Workshop Manuals and Repair Manuals

To bleed the brakes in a Peugeot 607, start with the brake furthest from the master cylinder (usually the rear passenger-side). Attach a clear plastic hose to the bleeder valve and submerge the other end in a container partially filled with brake fluid. With someone in the driver's seat to press the brake pedal, open the bleeder valve and have them slowly depress and hold the brake pedal. Close the valve, then repeat the process until no air bubbles are visible in the fluid. Continue this process for each brake in sequence, moving closer to the master cylinder.

To change the cabin air filter in a Peugeot 607, locate the filter housing, which is typically located behind the glove compartment or under the dashboard. Remove the housing cover and take out the old filter. Insert the new filter in the correct orientation, ensuring it fits securely. Replace the housing cover and make sure it is properly fastened. It is recommended to refer to the manual for specific instructions and diagrams related to the cabin air filter replacement process.

To change the oil in a Peugeot 607, start by locating the oil drain plug underneath the engine. Remove the plug and allow the old oil to drain completely. Once drained, replace the drain plug and refill the engine with the recommended amount and type of oil mentioned in the manual.

To change the spark plugs in a Peugeot 607, locate the spark plug wires or ignition coils depending on the engine type. Disconnect the wire or coil from the spark plug, and using a spark plug socket and ratchet, remove the old spark plug. Check the gap on the new spark plug, apply a small amount of anti-seize compound to the threads, and install the new spark plug. Reconnect the wire or coil and repeat the process for the remaining spark plugs.

To check the brake fluid level in a Peugeot 607, locate the brake fluid reservoir under the hood. The reservoir should have minimum and maximum level markings. Ensure the vehicle is on a level surface, remove the cap, and visually inspect the fluid level. If the level is below the minimum mark, add the recommended brake fluid as specified in the manual.

To check the tire pressure in a Peugeot 607, start by ensuring the tires are cold. Locate the valve stem on each tire and remove the valve cap. Use a tire pressure gauge to measure the pressure and compare it to the recommended pressure mentioned in the manual. If the pressure is too low, add air until the correct pressure is reached. If it is too high, release some air until the desired pressure is achieved.

To check the transmission fluid level in a Peugeot 607, start the engine and allow it to reach operating temperature. Locate the transmission dipstick, usually labeled with a bright color, and remove it. Wipe it clean, reinsert it fully, and then remove it again to check the fluid level. Ensure the level is within the recommended range. If needed, add the recommended type of transmission fluid as specified in the manual.

To perform a coolant flush in a Peugeot 607, start by allowing the engine to cool completely. Locate the radiator drain plug at the bottom of the radiator and place a container underneath to catch the old coolant. Open the drain plug and allow the coolant to drain fully. Once drained, close the drain plug and refill the system with a mixture of coolant and distilled water as specified in the manual. Run the engine with the radiator cap off to eliminate any air bubbles, then top off the coolant level as needed.

To replace a battery in a Peugeot 607, first, ensure the ignition is turned off and all electrical components are switched off. Locate the battery in the engine compartment and disconnect the negative terminal first, followed by the positive terminal. Remove any necessary brackets or clamps holding the battery in place, then carefully lift out the old battery and replace it with a new one of the same specifications. Connect the positive terminal first, followed by the negative terminal, and ensure they are securely tightened.

To replace a headlight bulb in a Peugeot 607, open the hood and locate the back of the headlight assembly. Twist and remove the bulb holder, then carefully remove the old bulb and replace it with a new one of the same type and wattage. Ensure the bulb is securely in place before reattaching the bulb holder.

To replace the windshield wipers in a Peugeot 607, lift the wiper arm away from the windshield and locate the release tab or button on the wiper blade. Press or slide the tab/button to release the old blade from the wiper arm. Attach the new wiper blade by inserting the arm into the corresponding slot or hook until it clicks securely in place. Gently lower the wiper arm back onto the windshield.

To reset the service indicator in a Peugeot 607, turn the ignition key to the "ON" position without starting the engine. Press and hold the trip reset button until the service indicator begins to flash. Release the button and turn off the ignition. When you restart the vehicle, the service indicator should be reset.

When troubleshooting an electrical issue in a Peugeot 607, start by checking the fuses related to the malfunctioning component. Inspect the wiring harness for any visible damage or loose connections. Utilize a multimeter to test for continuity and voltage at various points in the circuit. If necessary, consult the wiring diagrams in the manual to identify the correct wires and components involved. If the issue persists, it may be necessary to seek professional assistance.

It is recommended to change the air filter in a Peugeot 607 every 12,000 to 15,000 miles or as stated in the maintenance schedule provided in the manual. Regularly changing the air filter ensures clean air intake, optimal engine performance, and fuel efficiency.

The "Check Engine" light in a Peugeot 607 indicates a potential issue with the engine or its related components. It is advised to consult the manual for a list of possible causes and recommended actions to take. It is important not to ignore this warning light as it could lead to further damage if left unaddressed.