Pontiac Fiero Workshop Manuals and Repair Manuals

Every Manual available online - found by our community and shared for FREE. Enjoy!

Pontiac Fiero

Introduced in 1984, the Pontiac Fiero was a midengined sports car with hidden headlights from Pontiac division of General Motors.The Fiero was designed by George Milidrag and Hulki Aldikacti as a sports car. It was the first two-seater from Pontiac since the 1926 to 1938 coupes. Many technologies incorporated in the Fiero design such as plastic body panels were radical for its time. It was also the first mass-produced mid-engine sports car from a US manufacturer with over 370,000 units produced in just five years. Its production stopped in 1988.

Pontiac Fiero FAQ's

How do I change the oil in a Pontiac Fiero?

To change the oil in a Pontiac Fiero, start by draining the old oil from the oil pan, typically located underneath the engine. Remove the oil filter and replace it with a new one. Finally, refill the engine with the appropriate amount and type of oil recommended in the Pontiac Fiero automotive repair manual.

How do I check the battery in a Pontiac Fiero?

To check the battery in a Pontiac Fiero, visually inspect it for any signs of corrosion, damage, or leakage. Ensure the battery terminals are clean and securely tightened. If necessary, use a multimeter to measure the battery voltage. A healthy battery should typically read around 12.6 volts. If the battery voltage is significantly lower, it may be time to charge or replace the battery.

How do I check the transmission fluid in a Pontiac Fiero?

To check the transmission fluid in a Pontiac Fiero, start the engine and allow it to reach operating temperature. Locate the transmission dipstick, usually towards the back of the engine bay. Pull out the dipstick, wipe it clean, and reinsert it fully. Pull it out again and check the fluid level against the markings on the dipstick. Add transmission fluid as needed, following the manufacturer's recommendations.

How do I replace a headlight bulb in a Pontiac Fiero?

To replace a headlight bulb in a Pontiac Fiero, access the headlight assembly from the engine bay or the front wheel wells. Disconnect the electrical connector from the back of the bulb. Depending on the specific type of headlight bulb, twist it counterclockwise or release the retaining clip to remove the old bulb. Install the new bulb, ensuring it is properly seated and secure. Reconnect the electrical connector and test the headlight before reassembling.

How do I replace the air filter in a Pontiac Fiero?

To replace the air filter in a Pontiac Fiero, locate the air filter housing, usually found near the engine. Open the housing and carefully remove the old air filter. Inspect the housing for any debris or dirt, and clean it if necessary. Install the new air filter, ensuring it is properly seated, and close the housing securely.

How do I replace the brake pads on a Pontiac Fiero?

To replace the brake pads on a Pontiac Fiero, start by safely raising and supporting the vehicle. Remove the wheels, caliper mounting bolts, and then the old brake pads. Inspect the brake rotors for any damage or excessive wear. Install the new brake pads, reassemble the caliper, and repeat the process for all the wheels.

How do I replace the fuel filter on a Pontiac Fiero?

To replace the fuel filter on a Pontiac Fiero, locate the filter, usually along the fuel line underneath the vehicle. Use appropriate safety precautions, such as wearing safety glasses and gloves, and have a fire extinguisher nearby. Release the pressure from the fuel system, disconnect the fuel lines from the filter, and remove the old filter. Install the new fuel filter, reconnect the fuel lines, and ensure there are no fuel leaks.

How do I replace the serpentine belt on a Pontiac Fiero?

To replace the serpentine belt on a Pontiac Fiero, locate the belt tensioner, typically a pulley that can be moved with a wrench or socket. Rotate the tensioner to relieve tension on the belt, and then carefully remove the old belt from the pulleys. Install the new belt, following the proper routing diagram provided in the Pontiac Fiero automotive repair manual. Finally, release the tensioner to tighten the new belt.

How do I replace the windshield wipers on a Pontiac Fiero?

To replace the windshield wipers on a Pontiac Fiero, lift the wiper arm away from the windshield and locate the release tab or button on the wiper blade. Press or slide it to detach the old wiper blade from the wiper arm. Install the new wiper blade by sliding it into the arm until it clicks securely. Repeat the process for the other wiper blade.

How do I reset the check engine light on a Pontiac Fiero?

To reset the check engine light on a Pontiac Fiero, you can try disconnecting the negative battery terminal for a few minutes. However, it is important to note that simply resetting the light will not fix any underlying issues that caused the light to illuminate. If the check engine light keeps coming back after being reset, it is recommended to have the vehicle diagnosed by a professional or consult the Pontiac Fiero automotive repair manual for further guidance.

How often should I change the spark plugs in my Pontiac Fiero?

The recommended interval for changing spark plugs in a Pontiac Fiero may vary depending on the specific model and engine. However, as a general guideline, it is recommended to replace the spark plugs every 30,000 to 50,000 miles. Regularly inspecting the condition of the spark plugs and following the manufacturer's recommendations will help maintain optimal engine performance.

What is the recommended coolant for a Pontiac Fiero?

The recommended coolant for a Pontiac Fiero is typically a mixture of ethylene glycol coolant and distilled water. It is important to follow the manufacturer's recommended coolant type and ratio to ensure proper engine cooling and prevent corrosion. Consult the Pontiac Fiero automotive repair manual or the coolant reservoir cap for specific coolant recommendations.

What is the recommended tire pressure for a Pontiac Fiero?

The recommended tire pressure for a Pontiac Fiero is typically listed in the owner's manual or on a sticker located on the driver's side door jamb. It is important to follow these specifications to ensure proper tire performance, fuel efficiency, and overall vehicle handling. Regularly check and adjust the tire pressure to maintain optimal safety and performance.

What should I do if my Pontiac Fiero's engine overheats?

If your Pontiac Fiero's engine overheats, it is crucial to address the issue promptly to prevent further damage. Safely pull over to a safe location and turn off the engine. Allow the engine to cool down before attempting any inspection. Check the coolant level, radiator hoses, and the cooling fan operation. If necessary, consult the Pontiac Fiero automotive repair manual for further troubleshooting steps.

Pontiac Fiero Manuals Index

Pontiac Fiero Workshop Manual

Pontiac Fiero Owners Manual

Pontiac Fiero Misc Document

Related Models