Vauxhall Calibra Workshop Manuals and Repair Manuals

To change the cabin air filter in your Vauxhall Calibra, locate the cabin air filter housing, which is usually located behind the glove compartment or underneath the dashboard. Remove the housing cover by unlatching or unscrewing it. Take out the old cabin air filter and replace it with a new one, ensuring that it is properly aligned. Reattach the housing cover and make sure it is secured in place.

To change the oil in your Vauxhall Calibra, start by locating the oil drain plug underneath the engine and placing an oil pan beneath it. Remove the drain plug and let the old oil drain completely. Once drained, replace the drain plug and proceed to remove the oil filter, ensuring that the gasket from the old filter is removed as well. Install a new filter and pour in the recommended amount of fresh oil, checking the oil level with the dipstick to ensure it is at the correct level.

To check the coolant level in your Vauxhall Calibra, wait until the engine is cool and locate the coolant reservoir, which is typically a translucent plastic tank near the radiator. The reservoir will have high and low markings indicating the recommended coolant level. If the coolant level is below the low mark, add a mixture of coolant and distilled water until it reaches the appropriate level. It is important to use the correct type of coolant recommended by the manufacturer for optimal cooling system performance.

To check the tire pressure in your Vauxhall Calibra, start by locating the tire valve stems on each wheel. Remove the valve cap and use a tire pressure gauge to measure the pressure. Compare the measured pressure to the recommended pressure specified in your owner's manual or on the sticker inside the driver's door jamb. Adjust the tire pressure as needed using an air compressor or by releasing air with a valve stem tool.

To jump-start your Vauxhall Calibra, you will need a set of jumper cables and access to another vehicle with a charged battery. Park the two vehicles close together, but ensure they are not touching. Connect one end of the red jumper cable to the positive terminal of the dead battery and the other end to the positive terminal of the charged battery. Connect one end of the black jumper cable to the negative terminal of the charged battery and the other end to a metal surface away from the dead battery. Start the vehicle with the charged battery and let it run for a few minutes, then try starting your Vauxhall Calibra. Once started, remove the jumper cables in the reverse order.

To replace a fuse in your Vauxhall Calibra, start by locating the fuse box, which is usually located in the engine compartment or under the dashboard. Open the fuse box cover and locate the fuse that needs to be replaced. Use the fuse puller tool provided in the fuse box or a pair of needle-nose pliers to grip and pull out the old fuse. Insert a new fuse of the same amperage rating into the slot, making sure it is securely seated. Close the fuse box cover.

To replace a headlight bulb in your Vauxhall Calibra, start by opening the hood and locating the back of the headlight assembly. Remove the electrical connector from the back of the bulb by pressing the release tab and pulling it off. Unscrew the bulb holder and remove the old bulb. Insert the new bulb into the holder, making sure not to touch the glass part of the bulb with your bare hands. Screw the bulb holder back into place and reconnect the electrical connector.

To replace the fuel filter in your Vauxhall Calibra, start by relieving the fuel system pressure by removing the fuel pump fuse or relay and then starting the engine until it stalls. Once the pressure is relieved, locate the fuel filter, which is typically located along the fuel line. Disconnect the fuel lines from the filter using a fuel line disconnect tool. Remove the old filter and install the new one, making sure the arrow on the filter is pointing in the direction of fuel flow. Reconnect the fuel lines and start the engine to check for any leaks.

To replace the windshield wipers on your Vauxhall Calibra, start by lifting the wiper arm away from the windshield. Locate the release tab or button on the wiper blade connector and press or slide it to release the blade. Remove the old blade and attach the new one by sliding it into the wiper arm until it clicks into place. Gently lower the wiper arm back onto the windshield.

To reset the maintenance light on your Vauxhall Calibra, insert the key into the ignition and turn it to the "on" position without starting the engine. Press and hold the odometer reset button or trip reset button, depending on your model, until the maintenance light starts flashing. Release the button and turn off the ignition. Start the engine to verify if the maintenance light has been successfully reset.

It is recommended to change the spark plugs in your Vauxhall Calibra every 30,000 to 50,000 miles, or as specified in your owner's manual. However, if you notice any signs of misfiring, rough idling, or reduced fuel efficiency, it may be necessary to replace them sooner. Regularly replacing the spark plugs helps to maintain proper combustion and ensures optimal engine performance.

It is recommended to replace the air filter in your Vauxhall Calibra every 12,000 to 15,000 miles or at least once a year. However, if you frequently drive in dusty or polluted environments, it may be necessary to replace it more frequently. A clogged or dirty air filter can restrict airflow to the engine, leading to reduced performance and fuel efficiency.

For your Vauxhall Calibra, it is recommended to use DOT 4 or DOT 5.1 brake fluid. These types of brake fluid have high boiling points, which helps to prevent brake fade during heavy braking. It is important to use the correct brake fluid specified by the manufacturer to maintain optimal braking performance and safety.